How to install, replace and look after grips
Step-by-step instructions for fitting grip tape, sleeves, panels, bar tape and more.
- How to install grip tape on a pistolClean the frame properly, line up one reference edge, and use heat. Ten minutes of care adds a year to the wrap.
- How to install a slip-on grip sleeveA tight sleeve is a good sleeve. The trick is getting it on without a fight.
- How to change an AR-15 pistol gripOne screw holds the grip on. One small spring is waiting to escape when you take it off.
- How to replace 1911 gripsFour screws, two panels. The details are the bushings and not overtightening.
- How to replace revolver gripsUsually one screw. Go gently around the frame finish and the locating pin.
- How to regrip golf clubsTape, solvent and a steady hand. About five minutes a club once you have done one.
- How to wrap an overgripStart at the butt, keep a little tension and overlap evenly. The direction depends on which hand you play with.
- How to wrap bar tapeStart at the bar end, keep even tension and finish neatly at the top. Direction matters.
- How to install and remove bike gripsLock-ons need a hex key. Push-on grips need rubbing alcohol or compressed air, and never oil.
- How to install motorcycle gripsGlue, a gap at the throttle housing, and a check that the throttle snaps shut. That last one is not optional.
- How to measure your hand for grip sizeA ruler and thirty seconds. The measurement differs by sport.
- How to clean grips and restore their tackMost grips lose traction to dirt and skin oil before they wear out. Soap and water bring a lot of them back.