How to regrip golf clubs

Tape, solvent and a steady hand. About five minutes a club once you have done one.

Last reviewed November 22, 2026. How we evaluate

What you need

  • New grips, with the correct core size
  • Double-sided grip tape, two inches wide
  • Grip solvent or mineral spirits
  • A hook blade or utility knife
  • A vise with a rubber shaft clamp
  • A tray to catch solvent

Steps

  1. Clamp the shaft in the rubber clamp with the clubface square.
  2. Cut the old grip off lengthwise, cutting away from yourself. On graphite shafts use a hook blade so you do not score the shaft.
  3. Peel off the old tape. Solvent or gentle heat helps. Clean the shaft.
  4. Apply a strip of double-sided tape along the shaft, the length of the grip, with half an inch overhanging the butt end. Add extra wraps here if you want a larger grip.
  5. Peel the backing and twist the overhang into the end of the shaft.
  6. Cover the vent hole in the grip with a finger, pour solvent inside, pinch the mouth shut and shake.
  7. Pour that solvent out over the full length of the tape.
  8. Push the grip onto the shaft in one firm motion until the butt of the shaft meets the end of the grip.
  9. Align the grip’s markings with the clubface while it still slides.
  10. Wipe it down and let it dry for several hours before play.

Questions people ask

How many wraps of tape should I use?

One wrap gives the grip’s stated size. Each extra wrap adds about 1/64 inch.

Can I reuse a grip?

Sometimes, if you remove it with compressed air or a solvent needle instead of cutting it.