How to replace revolver grips

Usually one screw. Go gently around the frame finish and the locating pin.

Last reviewed November 22, 2026. How we evaluate

Two-piece grips

  1. Unload the revolver. Open the cylinder and check every chamber.
  2. Unscrew the grip screw most of the way.
  3. Press on the screw head to push the opposite panel off, then remove the screw and the other panel. Do not pry against the frame.
  4. Note the locating pin near the bottom of the grip frame. New panels have a recess for it.
  5. Fit the new panels over the pin, check they sit flush, and install the screw until snug.

One-piece grips that slide on

  1. Remove the old grips as above.
  2. Fit the stirrup supplied with the grip over the frame’s locating pin, if your grip uses one.
  3. Slide the grip up onto the frame from below until it seats.
  4. Insert the screw through the bottom of the grip into the stirrup and tighten until snug.

Ruger peg frames

On the GP100, SP101 and LCR the grip slides over a peg and is held by a screw or pin arrangement that differs by model. Follow the instructions packed with the grip.

Afterward

Check that the grip does not touch the cylinder release or block a speedloader, and that the hammer and trigger move freely through a full cycle with the revolver unloaded.