How to wrap bar tape

Start at the bar end, keep even tension and finish neatly at the top. Direction matters.

Last reviewed November 22, 2026. How we evaluate

Before you start

Remove the old tape and adhesive. Tape the cables or hoses to the bar with electrical tape where you want them. Roll the brake hood covers forward.

Steps

  1. Begin at the end of the drop with half the tape’s width hanging off the end. This overhang gets tucked into the bar by the plug.
  2. Wrap toward the inside of the bar over the top. The usual convention is clockwise on the right side and counterclockwise on the left, viewed from behind the bike, so your hands tighten the tape as they rotate.
  3. Overlap each turn by a quarter to a third of the tape’s width, with firm, even tension. Stretch a little more on the outside of bends.
  4. At the lever, stick the short extra strip across the back of the clamp, then wrap up and over the lever body in a figure of eight so no bar shows.
  5. Continue along the top to where you want the tape to stop, usually a couple of inches from the stem.
  6. Cut the tape at an angle so the last turn ends square, and secure it with electrical tape followed by the finishing strip.
  7. Tuck the overhang into the bar end and press in the plug. Roll the hoods back.

Questions people ask

Why does my tape unravel on the tops?

It was wrapped in the direction that loosens under your hands, or without enough tension.

Can I rewrap used tape?

Tape with a gel or silicone backing can often be rewrapped. Adhesive-backed tape usually tears.