How to wrap an overgrip
Start at the butt, keep a little tension and overlap evenly. The direction depends on which hand you play with.
Steps
- Remove the old overgrip and the plastic film from the new one.
- Find the tapered end. Stick its adhesive tab to the bottom edge of the butt cap.
- Wrap once around the butt so the edge sits flush with the end of the handle.
- Angle upward and continue around the handle, overlapping each turn by about an eighth of an inch. Keep gentle tension so it lies flat.
- Right-handed players usually wrap so the tape moves away to the right as it climbs. Left-handed players reverse it. That keeps the overlaps from peeling under your hand.
- At the top, mark where the wrap ends level, unwind a little, and cut at an angle so the edge finishes straight.
- Secure it with the finishing tape, and roll the rubber collar down over the tape if your racquet has one.
Paddles and short handles
Pickleball paddles, squash and badminton racquets have shorter handles. Use the same method and trim the extra length. Some players use more overlap to build up a thin handle.
Questions people ask
How much should the overgrip overlap?
About an eighth to a quarter of an inch. More overlap builds thickness and can leave you short at the top.